Your laptop’s broken screen is more than just an annoying eyesore. It can render a device useless, making the task of troubleshooting and fixing it more daunting. Fortunately, no matter the model or type of laptop you own, you can easily repair a broken screen if you take the time and patience to follow some steps.
However, as fixing a laptop screen is accompanied by several pitfalls, it’s in your best interest to understand the entire process rather than trying to do-it-yourself. Below, we’ll discuss the necessary steps to fixing a broken laptop screen, so you can avoid the mistakes commonly made by novice repairpersons.
Step 1: Make the Necessary Preparations
Before you begin the actual repair process, there are a few preparations you need to make to ensure that the process goes as smoothly as possible. Make sure you have the following items on hand before you start:
- Safety glasses – these should be worn at all times when working with broken glass.
- Screwdrivers – you will need Phillips and flathead screwdrivers.
- Suitable gloves – avoid sharp edged gloves, if you can.
- A vacuum cleaner – to easily pick up small pieces of debris.
- A lint-free cloth – to clean the laptop frame.
- A container – for storing all of your screws and other small parts.
Once you have all of these items, you are now ready to begin the repairs.
Step 2: Removing the Old Screen
Step 2: Removing the Old Screen
It’s time to remove the broken screen. This isn’t especially difficult, but you should be careful and take your time. First, you’ll need to unplug all the cables connected to the LCD panel. Then, loosen the screws at the sides of the panel. You should now be able to pull the broken panel away from the housing. Depending on the make and model, you might also need to remove a few trim pieces with a mini screwdriver before you can take the broken panel away. Before moving forward with installation of the new screen, be sure to dust off the area around the LCD display to get rid of any dirt or debris.
Step 3: Replacing the Screen
Once you have disconnected the old screen from your device, it’s time to set up the replacement. Installing the new screen should be a simple procedure, as long as you take the necessary precautions and have all the necessary tools. Here are the steps to take:
- Carefully lay the laptop flat and unscrew the screws on the back of the device holding the bezel in place. Remove the bezel.
- Remove the screws attaching the lcd to the hinges and remove the lcd.
- Attach the new lcd to the hinges in the same way that the old one was attached and use the screws provided to secure it in place.
- Replace the bezel and screw it back in place before closing the laptop lid.
Your laptop should be as good as new after performing these steps. Once the replacement screen is installed, turn the laptop on to ensure it’s working properly before closing it up.
In conclusion, it is not always necessary to replace your laptop screen if it’s broken. This step-by-step guide has shown you how to easily and affordably fix your laptop’s broken screen with minimal fuss. With the right tools and materials, and a bit of knowledge, you can easily give your laptop a brand new look – and save yourself a lot of money in the process!